Rahasia Blackberry CDMA

cara menampilkan settingan blackberry cdma

    ADVANCED USER ONLY !!!!


    pertama cari dulu softwer qpst n qxdm nya

    udah dapet install ke pc...

    pertama....gw copas aja dari forum sebelah yah.....

    http://www.mobile-files.com/forum/sh...ad.php?t=70463
    http://www.mobile-files.com/forum/sh...d.php?t=100553
    http://www.mobile-files.com/forum/sh...ad.php?t=81157


    1) Install QXDM (2.08 Release Recommended)

    2) Install Blackberry Desktop Manager (Should create two RIM Virtual Ports on PC)

    3) Run Blackberry Desktop Manager the entire time (Device should show connected)

    4) Using UniCDMA read MSL/SPC from the following:

    Blackberry 8130 Pearl
    Address: 0x106C0000 Length: 1703936
    Address: 0x10130000 Length: 500000

    Blackberry 8330 Curve
    Address: 0x10700000 Length: 1703936

    Blackberry 8703e
    Address: 0x10050000 Length: 1703936

    Blackberry 8800
    Address: 0x10630000 Length: 1703936

    Blackberry 8830 WE
    Address: 0x10600000 Length: 500000

    5) With WinHex (or equivalent HEX Editor) search for 6-digit code in the memory dump by using the GATHER TEXT feature in the SPECIALIST menu. Use this tool to filter out unnecessary characters. I recommend setting the GATHER TEXT feature to 6 succession, only numbers and have Unicode characters tolerated.

    6) Once you obtain the SPC/MSL, exit UniCDMA and run QXDM.

    7) Configure QPST (globe in system tray) and QXDM to the correct ports, phone must show detected.

    8) Using QXDM (ensure VIEW is set to COMMAND OUTPUT) type the following commands:

    a) mode offline-d
    Turns radio off and sets to service mode. Check phone radio is off.

    b) spc "******"
    Replace asteriks with the 6 digit code. Output should read successful.

    c) pr_list_wr 0 "C:\prl_1039.prl"
    If needed change file path to location of PRL. Output should read successful.

    d) nv_write sec_code {"000000"}
    Optional: use this command to change code to zeros or another 6 digits.

    e) mode reset
    Reboots phone to reset mode.

    9) Finally, through the phone type #4357* (#HELP*) to verify the PRL write.

    ##6digitMSL and SEND to start NAM Programming

    NOTE: If PRL reverts (SPRINT), use QXDM command to read and disable NAM_LOCK:
    a) nv_read nam_lock (should read enabled, which we'll change in the next command)
    b) nv_write nam_lock 0 0 (disables)

    Then proceed with UniPST and the RIM DLL to edit the registration ID (and List) to "2004"

    ----------------------------------


    catatan:::bb nya harus udah unlcok yah....tanda nya kalo pencet ##000000 dial
    udah bisa masuk ke spc edit

    Thanks & Regards